Polyethylene Terephthalate Recycling

Polyethylene Terephthalate Recycling

I.Product introduction ● heavy load bearing, large quality inertial wheel design, Strong crushing force. ● easy to disassemble design, cleaning capacity, maintenance side; ● high quality high speed steel cutter, sharp blade, durable; ● power chain protection, ensure safe operation. Notes: 1....
Chat Now

Product Details


I.Product introduction

● heavy load bearing, large quality inertial wheel design,

Strong crushing force.

● easy to disassemble design, cleaning capacity, maintenance side;

● high quality high speed steel cutter, sharp blade, durable;

● power chain protection, ensure safe operation.

Notes:

1. Before starting, the driving wheel should be moved one or two times by human power to ensure its flexibility before starting. Wait for the crusher to run Feed only after normal.

2. Before stopping operation, stop feeding and clean the material in the machine before cutting off the power of the motor.

3, in the operation of the bearing should pay attention to the temperature, to make the bearing maintain a good lubrication state, and pay attention to the sound and vibration are not abnormal.

When abnormal conditions are found, stop the vehicle to check whether it is stuck by non-breakable objects or whether the parts are damaged.

4, to keep the crusher feed uniform, to prevent overload. Prevent metal, wood and other non-breaking objects from falling into the aircraft. Cannot be broken, the feed moisture should not be too high; When wet crushing, it is necessary to maintain an appropriate amount of water to prevent blockage and decrease due to insufficient flushing Production capacity.

5. Check whether the particle size of crushing products meets the requirements. If there are too many particles over the specified size, the cause should be found (e.g Large gap, wide discharge port, hammer wear, etc.), and take appropriate measures to eliminate.

6, the crusher stop, to check whether the fastening bolt is firm, easy to wear the wear degree of the parts. For the tooth crusher, still Parking opportunities should be used to remove timber caught between teeth.

7. The worn parts should be replaced or repaired in time.

8, crusher safety device, to maintain a good state, never to save time, and make the safety device failure.

Used to crush PPS, PSF, PI, PEEK, BBS and other hard plastics.

II.The characteristics :

(1). Adopt imported special tool steel to refine the cutter, the gap of the cutter can be adjusted, it can be repeatedly sharpened, and it is durable.

(2). High strength steel screws are used to tighten the blade and the blade holder, with strong bearing capacity.

(3). Low speed, sound insulation, minimal noise.

(4). The motor is equipped with over-load protection and power interlock protection device, which can double protect the safety of motor and operator.

(5). The hopper adopts optimized design and special anti-rust treatment to avoid leakage and pollution of materials in the crushing process.

(6). Separated design, hopper, main body and base of sieve screen can be easily disassembled and cleaned.

(7). The perfect design of discharging device makes it very convenient for operators to clean up.

(8). Stepped knife design, especially strong crushing force.


Inquiry